Finishing Passes for Dynamic Mill and Area Mill Toolpaths

Mastercam 2025 introduces the ability to add finish passes to 2D Dynamic Mill and Area Mill toolpaths. Use the new Finish Passes page to add high speed finishing passes along the selected boundaries of the toolpath. After selecting the Finish pass option, use the other parameters on this page to further define the finish pass, such as feed rate and spindle speed overrides. Use the Stock to leave options on the Cut parameters page to enter the amount of material to leave for the finish passes.

In addition to the Finish Passes page, there is the new Lead In/Out page which allows you to set specific lead in and out options for finish passes.