Apply to all Finish Passes checkbox for Circle Mill

Find the new Apply to all finish passes checkbox in the Finish box on the Finishing page of the 2D Toolpaths – Circle Mill dialog box. Use this option to apply finish passes after the last finish pass for each defined depth set by the Finish passes parameter. Previously the user only had the ability to apply a spring pass at the last depth increment of a finishing pass.

This feature is helpful for reduced shank tools that are incapable of finishing the entire depth of the hole in one pass. This option also provides consistency throughout the product as the same checkbox is available for 2D Toolpaths – Contour.

The new option is available only when you select the Finishing and Finish checkboxes, as shown in the following image.